MASSEY FERGUSON 5400 - Removing and Refitting the Cover

Massey Ferguson 5400 - Issue 1.b
09B01.10
Right-hand cover – 57 l/min Open Centre
C . Removing and refitting the cover
Preliminary operations
1. Immobilise the tractor. Chock the left rear wheel.
2. Apply the parking brake.
3. Chock between the frame and the front axle
(optional).
4. Partially bleed the rear axle housing.
5. Take off the wheel concerned. Position an axle
stand.
Removal (Fig. 7)
6. Disconnect the clogging indicator harness (12).
7. Remove the 15 micron filter(s) (14) and the support
(depending on option).
8. Remove the strainer (18) to access the partially
hidden screw (4).
9. If the tractor is fitted with a trailer braking mecha-
nism, remove the spool valve.
10. Disconnect and block:
- the hose (1) to the auxiliary circuit
- the rear differential lock tube (2) and the hose (8)
from the front differential lock control (if fitted)
- the 4WD clutch supply pipe (10) for tractors
fitted with this option
- the PTO brake supply pipe (3).
- the Orbitrol spool valve supply pipe (9) via the 15
micron filter(s) (14)
- the 17 bar hydraulic cover supply pipe.
11. Disconnect the harness of the engine speed
sensor (16) and filter switch (19) (Fig. 7).
MA-09-00026A
1
19
4
2 3 16
18 10 9 14 8 12
Fig. 7