MASSEY FERGUSON 5400 - Removing the Differential Assembly

Massey Ferguson 5400 - Issue 1.a
06E01.11
GPA20 differential
E . Removing the differential
assembly
Preliminary operations
26. Split the tractor between the gearbox and the rear
axle (the cab remains integral with the gearbox)
(Fig. 10).
27. Remove the wheels.
28. Separate the left- and right-hand trumpet housings
from the centre housing (see section 6).
29. Remove the lift cover (see section 6).
30. Disassemble the hitch support (see section 6).
Remove the upper PTO cover, the drive pinion and
the layshaft (see section 7).
31. Take off the pipe (40) (Fig. 11).
Removal
32. Remove the brake pistons (see section 6).
33. Carefully place a sling on the differential assembly
using a clamp (Fig. 12).
34. Before working on the screws (56) and the nut
(42). Loosen the screws (56) and nut (42) alter-
nately to gradually release the spring (6).
R
EMINDER: See special points § B.
35. Remove the flange (9), spring (6), coupler (7) and
washer (11).
36. Take out the screws (26).
37. Take off the flange (25).
38. Take out the differential assembly from the centre
housing (Fig. 12).
Fig. 10
Fig. 11
Fig. 12