MASSEY FERGUSON 5400 - Reassembly

Massey Ferguson 5400 - Issue 1.a
06F01.8
GPA20 hitch / Linkage
D . Reassembly
NOTE: Fit the rings (13) up against face "A" (Fig. 7).
27. Check and clean all components. Replace any
defective parts.
28. Clean the mating faces of the lift cover and of the
spool valve support.
29. Fit the rings (8) home in the cover.
30. Fit the cup plug (17) smeared with Loctite 542
flush with the cover (2-speed PTO).
31. Fit the lift shaft (4) and the cam (9) in the cover (Fig.
8).
N
OTE: Ensure that the direction of the shaft and the
position of the cam are correct.
32. Tighten the set screws (14) smeared with Loctite
241 to a torque of 5 Nm.
N
OTE: Protect the splines of the shaft. Lubricate
the O'rings before fitting (Fig. 9).
33. Grease the splines of the shaft (4) (Anti-Seize
Grease or equivalent).
34. Fit the lift arm (5) (sensor side), the washer (1), the
lockwasher (3) and the screw (2).
N
OTE: Grease the face of the cover (Anti-Seize
Grease or equivalent) before fitting the arms.
35. Tighten screws (2) to a torque of 360 - 470 Nm.
Fig. 7
Fig. 8
Fig. 9