Massey Ferguson 5400 - Issue 1.a
05E02.18
Selector cover - GBA20 with Power Shuttle
E . Fitting and adjusting the gear
linkage
Cab side
Preparation (Fig. 11)
64. On the end of the link control rod (1) shaped with
an angle of 166°, position the ball joint (2) as shown
in Fig. 11. Tighten nut (3).
65. Tighten the ball joint (4) up against the cable (6).
Tighten nut (5).
Assembly (Fig. 11)
66. Place the bracket (7) on a workbench.
67. On the bracket, fit and tighten:
- the gear shift lever,
- the previously prepared link control rod and
cable.
68. Refit and secure the bracket onto the right-hand
wheel housing of the cab. During this operation,
ensure the link control rod and cable are inserted
through the ports in the compartments.
Fit the protection rings.
Fig. 11
To Next Page
Loading...
