MASSEY FERGUSON 5400 - Page 157

Massey Ferguson 5400 - Issue 1.a
05E02.19
Selector cover - GBA20 with Power Shuttle
Selector cover side
Preparation (Fig. 12)
69. Screw the threaded rod (9) (fitted with nuts (3) and
the ball joint (4)) onto the link control rod (1).
70. Tighten the ball joint (5) up against the cable (6).
Tighten nut (7).
Assembly (Fig. 12)
71. Tighten and lock the other end of the ball joint (5)
onto the cam (8).
72. On the previously fitted bracket (2) and lever L ,
position the cam (8) and its extension piece (10).
Fit the pins (11), and lock them in place with new
pins.
73. Fit the ball joint (4) on the lever L. Fit the washer
and tighten the locknut.
Adjusting the link control rod (1) (Fig. 12)
74. Turn the threaded rod (9) and ball joint (4) to obtain
a dimension X of 17 ± 1 mm between the two
nuts (3) when they are tightened.
Adjusting the cable (6) (Fig. 12)
75. Adjust the end-point to balance (as far as possible)
dimensions “C” and “D”. Tighten nuts (12)
without altering the adjustment.
Fig. 12