MASSEY FERGUSON 5400 - Page 158

Massey Ferguson 5400 - Issue 1.a
05E02.20
Selector cover - GBA20 with Power Shuttle
Check for the proper engagement of each
gear ratio and the position of the gear shift
lever in the opening of the console.
IMPORTANT: This check should be performed with the
dust cover of the gear shift lever temporarily removed.
76. Engage each gear ratio. During this operation,
check that the lever is never closer than 5 mm
from the edge of the console (Fig. 13 - Fig. 14).
Results
• Lever movement is not hindered in any way
by the console
Adjustment is correct. Refit the boot.
• Lever movement is hindered by the console
The lever is positioned incorrectly. Readjust the
link control rod (1) (Fig. 12) on the selector cover
side according to the following instructions:
- If the problem concerns the 1st or 3rd gears
(Fig. 13), reduce dimension X (Fig. 12).
- If the problem concerns the 2nd or 4th gears
(Fig. 13), increase dimension X (Fig. 12).
- If the problem concerns lateral movement of
the lever between the 1-2 and 3-4 gear paths
(Neutral position) (Fig. 14), adjust the cable
end-point(6) (dimensions C and D) (Fig. 12).
Tighten nuts (12).
MA-05-00431B
1
3
2
4
Fig. 13
MA-05-00431B
1
3
2
4
Fig. 14