MASSEY FERGUSON 5400 - Assembling and Adjusting the Control

Massey Ferguson 5400 - Issue 1.a
07E01.14
GPA20 - GSPTO
104. Check for the oil tightness of:
- the mating face of the cover under the rear axle
housing
- the right-hand hydraulic cover (if removed)
- the hydraulic unions.
G . Assembling and adjusting the
control
105. Place lever L (Fig. 17) in GSPTO position (clutch
engaged) (Fig. 18).
106. Screw the clevis (1) flush with the threaded end of
the cable (6).
107. Fit the clevis (1) to lever L using the clip (7). Tighten
nut (2).
108. Adjust the sheath end (5) so that the nut (3) is flush
with the end of the threaded part.
109. Tighten nut (4) and check that the cable is not
constrained in any way.
110. Place the link (8) in “clutched” position “a”
(Fig. 19) and ensure that it is correctly locked.
111. Screw clevis (1) flush with the threaded part of
cable (6) (Fig. 19).
112. Fit clevis (1) to link (8) using clip (7). Tighten nut (2).
113. Adjust sheath end (5) using nut (4) while ensuring
that link (8) is still locked in position “a”.
114. Tighten nut (3). Check correct operation of the
control in “declutched” position “b” and check
that the cable is not constrained in any way when
in position “a”.
115. Check for correct operation of the instrument
panel indicator light.
Fig. 17
Fig. 18
Fig. 19