MASSEY FERGUSON 5400 - Disassembling the Power Take off (4 WD Version)

Massey Ferguson 5400 - Issue 1.a
07E01.12
GPA20 - GSPTO
79. Take out the guide studs. Tighten the screws to a
torque of 130 - 170 Nm.
80. Reconnect the GSPTO control cable (1) (Fig. 6).
81. Adjust the control (see § G).
82. Top up the oil level in the rear axle.
83. Refit the hook (for tractors fitted with an
auto-hitch, check correct operation). If adjustment
is necessary, see section 6.
84. Check GSPTO operation.
85. Check for the oil tightness of:
- the mating faces
- the cover beneath rear axle housing
- the hydraulic unions.
E . Disassembling the power take off
(4WD version)
86. Remove the guard, the 4WD shaft and the lubri-
cating pipe of the engine clutch or Power Shuttle.
Disassemble shaft (8). Carry out operations 1 to
14.
N
OTE: If servicing is required on the 4WD clutch
assembly, the cones and cups, the shaft and
needle bearing, see section 8.
If the pinion (31) is removed, it is necessary to
remove the right-hand hydraulic cover.
87. Raise the tractor using a jack. Position an axle
stand. Disassemble the wheel.
Tractors with no creeper unit
88. Drive out the double pins (25) (26) from the
coupling sleeves (27) (28).
89. Slide the sleeves towards each other on the shaft
(29).
90. Remove the assembly (shaft and sleeves).
91. Take off circlip (30) and remove the pinion (31).
Tractors with a creeper unit
92. Remove the fork, the sleeve assembly, the link
shaft and the coupler.
93. Take off circlip (30) and remove the pinion (31).