MASSEY FERGUSON 5400 - Fitting and Adjusting a Control Cable

Massey Ferguson 5400 - Issue 1.b
09E01.22
Auxiliary spool valve
I . Fitting and adjusting a control
cable
Cab side
Special points
• The pins (2) should be fitted with the threads slightly
smeared with loctite 241 or equivalent. (Fig. 17).
• The figures in the dark circles 1 to 3 show the
assembly order of the levels which control the spool
valves.
• The fitting of a fourth control level is provided for on
the cab consol. It must be placed to the left of lever
1 (viewed from the driver’s seat)
• The friction washers (1) should be smeared with
molybdenum disulphide grease before fitting.
• The nuts (3) must be tightened so oas to obtain a
slight resistence for the levers during operation.
On base plate (6) and levers ()
NOTE: Depending on the type of spool valve, the
clevis (4) may be fitted on link "A" or "B".
Fitting A : Normal spool valves
Fitting B : Spool valves with floating position.
17. Pass the cable through the flange (9) located at the
rear right of the cab and then through the yoke (8).
N
OTE: The hole in yoke (8) is eccentric (Fig. 17). To
lift a control for a spool valve with floating position,
the hole must be at the top as to correctly align the
cable and its fastenning.
18. Scew the clevis (4) flush with the threaded part of
the cable (7) and fit it on link "A" or "B" of lever
concerned. Fit the clip (5).
19. Tighten the nut on the clevis and check that the
cable is not constrained in any way.
Fig. 17