MASSEY FERGUSON 5400 - Page 525

Massey Ferguson 5400 - Issue 1.b
09E01.23
Auxiliary spool valve
Spool valve side (Fig. 19)
Special points (Fig. 18)
• If a stirrup (4) needs to be replaced, remove and
replace it without turning the spool (2) of the spool
valve.
• When assembling, the pins (3) should be lightly
smeared with molybdenum disulfide or AS767
grease or equivalent.
20. Screw the clevis (1) to the threaded part of the
cable (2).
21. Attach the clevis to the stirrup (4) using the
hook (3). Tighten nut.
22. Adjust the stop (5) with the nut (6).
23. Tighten nut (7) and check that the cable is not
constrained in any way.
Check
24. Start the tractor engine. Using the relevant
lever (2) (Fig. 17), check that the three or four posi-
tions of the spool valve (depending on model)
engage correctly.
In case of faulty operation, separate the spool
valve control and check the movement of the
spool. If it operates correctly, check the cable
adjustment again.
Fig. 18
Fig. 19