MASSEY FERGUSON 5400 - Assembling and Adjusting the 4-Speed LSPTO Control

Massey Ferguson 5400 - Issue 1.a
07B01.16
Intermediate shaft - Driving pinions - GPA20 brake
G . Assembling and adjusting the
4-speed LSPTO control
118. Move the control lever L (Fig. 20) to the 1550 rpm
economy position.
119. Screw the clevis (1) flush with the threaded end of
the cable (6) (Fig. 21).
120. Fit clevis (1) on lever L using the clip (7).
121. Adjust the sheath end (5) so that the nut (3) is flush
with the end of the threaded part.
122. Tighten nut (4) and check that the cable is not
constrained in any way.
123. Place lever M in the 1550 rpm economic position
(a) (Fig. 22) (sleeve locked with the coupler pinion,
the fork locked).
124. Screw the clevis (1) flush with the threaded end of
the cable (6) and fit it onto lever M with the clevis
pin (7).
Tighten nut (2).
125. Adjust the sheath end piece (5), checking that lever
M remains locked.
126. Tighten nuts (3) (4) and check that the cable is not
trapped in any way.
127. Check the locking of the control in the 2000 rpm
position (b) and check for the correct operation of
the indicator light on the instrument panel.
Fig. 20
Fig. 21
Fig. 22