Massey Ferguson 5400 - Issue 1.b
09B01.20
Right-hand cover – 57 l/min Open Centre
108.
Position the composite seal (3) and seal (38)
(Fig. 24).
109.
Centre the low flow rate stage (37) and assemble
the closing plate (1) according to the marks made
during disassembly.
110.
Tighten screws (2) (4) to a torque of 40 - 47 Nm.
111.
Manually check for the free rotation of the pump.
112.
Reassemble and refit the cover (see § E and C).
H . Adjusting the engine speed
sensor
113.
Fit the engine speed sensor (16), having lightly
smeared the threads with Loctite 577 or equivalent
(Fig. 25).
114.
Screw the sensor fully home without forcing it until
it makes contact with the pump pinion (29). Then
unscrew it three quarters of a turn so as to obtain
a gap of approximately 1mm between the sensor
and the pump pinion.
Tighten the nut (1) to a torque of 5 - 7 Nm.
Fig. 24
Fig. 25
To Next Page
Loading...
