MASSEY FERGUSON 5400 - Removal

Massey Ferguson 5400 - Issue 1.a
05B02.5
Input unit - GBA20 with Power Shuttle
C . Removal
4. Remove the forward clutch from the Power
Shuttle (see section 5).
5. Take out the PTO shaft (1) from the gearbox
(Fig. 4) and mark its position.
6. Remove union (91) (Fig. 2).
7. Extract the transfer pipe (88) (Fig. 2, pressure
connector line, lubrication).
8. Disconnect and remove the progressivity
sensor (1) located above the right-hand side of the
selector cover (Fig. 3).
9. Sling the input unit using tool 3378225M11, a
handling bar made locally (see § G) and a suitable
lifting device as in Fig. 4.
N
OTE : The sling hides two diametrically opposed
screws (1) on the input unit (Fig. 5). Before fitting
the tool on the unit, remove these screws.
542
88
92
91
MA-05-02003A
Fig. 2
1
MA-05-06014A
Fig. 3
MA-05-06008A
1
Fig. 4