MASSEY FERGUSON 5400 - Refitting the Left-Hand Flange and the Differential Lock Assembly

Massey Ferguson 5400 - Issue 1.a
06E01.9
GPA20 differential
D . Refitting the left-hand flange and
the differential lock assembly
15. Fit the O'ring (1).
16. Assemble washer (11), mobile coupler (7) and
spring (6).
17. Refit the assembly in the left-hand flange (9).
Flange fitting method (9) (Fig. 7)
18. Screw two guide studs “G” (L = 60 mm approx.)
to the centre housing (Fig. 7).
Check for the presence of the ring (45) (Fig. 8).
Position the flange assembly (9) turning it so that
the oil passage is at the bottom.
Fit washer (44). Tighten alternately and uniformly
the screw (56) and nut (42) to a torque of 85 - 100
Nm.
R
EMINDER: See special points § B.
Replace the guide studs with two other screws
and tighten them to the previously indicated
torque.
19. Fit pipe (40) and union (39) (Fig. 3).
Fig. 7
Fig. 8