MASSEY FERGUSON 5400 - Removing and Refitting the Cover

Massey Ferguson 5400 - Issue 1.a
05E02.11
Selector cover - GBA20 with Power Shuttle
C . Removing and refitting the cover
Preliminary operations
1. Immobilise the tractor. Chock the left rear wheel.
2. Apply the handbrake.
3. Chock between the frame and the front axle.
4. Drain the gearbox.
5. Raise the rear right-hand side of the tractor with a
suitable jack.
6. Disassemble the wheel. Position an axle stand.
7. Remove the right-hand footstep and any
surrounding elements that might hinder the cover
removal.
Removal (Fig. 6)
8. Disconnect the harness of the cell “C” (Fig. 6).
Remove the ball joint (4). Remove screw (3).
9. Remove pins (11). Remove the ball joint (5).
10. Note the adjustment of the cable (6). Slightly
loosen the top nut (12) and separate the cable from
the bracket (2).
11. Disconnect the control cable (1) from the creeper
unit on tractors fitted with this option (Fig. 7).
12. Remove the screws (3) (4) and the nut (6), marking
the location of the grounding lug (2) (Fig. 1).
13. If fitted, remove the bracket (2) of the creeper unit
control cable (Fig. 7).
14. Loosen and remove the selector cover.
Fig. 6
Fig. 7