MASSEY FERGUSON 5400 - Removing and Refitting Spool Valves

Massey Ferguson 5400 - Issue 1.b
09E01.12
Auxiliary spool valve
D . Removing and refitting spool
valves
Auxiliary spool valves can be removed and refitted
directly on the tractor by removing each unit and
leaving only the main
support fitted to the lift cover (Fig. 3).
Preliminary operations
9. Remove unit(s) close to the auxiliary spool valves
which might obstruct access to them.
(Example: hydraulic valve for automatic hook).
10. Disconnect:
- the supply hose (3) from the right-hand hydraulic
cover (Fig. 9);
- the outlet hose (2) to the lift control spool valve
(Fig. 9).
11. Separate the control cables of the supports and
spool valves.
Removal
12. Remove the locknuts (1) located at the end of the
spool valve set (Fig. 9).
13. Release and remove each hydraulic component
after visually noting its position.
I
MPORTANT: Do not discard or lose plates and seals.
N
OTE: The spool valves are fitted either side of the
main support.
14. If necessary (Fig. 10):
- Remove quick-disconnect couplings (A) and (B).
- Remove pins (1) and screws (2). Separate the
cable support (3) from the spool valve.
Fig. 9
Fig. 10