Massey Ferguson 5400 - Issue 1.b
09E01.13
Auxiliary spool valve
Refitting
Refitting operations are not difficult. They therefore
require carrying out the removal operations in reverse
order.
However, during refitting it is necessary to ensure that:
- parts to be assembled are not dirty, corroded,
dented, etc.
- seals are oiled.
The locknuts fitted at the end of the spool valve set
should be tightened to a torque of 30 - 33 Nm.
Final operations
15. Check the correct operation of each spool valve on
the two, three or four positions (depending on
model).
16. Check the pressure on quick-disconnect couplings
(see Hydraulic tests, section 9).
To Next Page
Loading...
