MASSEY FERGUSON 5400 - Reassembling the Power Take off (4 WD Version)

Massey Ferguson 5400 - Issue 1.a
07E01.13
GPA20 - GSPTO
F . Reassembling the power take off
(4WD version)
94. Check and clean all components. Replace any
defective parts.
In case of servicing on the pinion (31)
Tractors with a creeper unit
95. Refit the pinion (31). Refit the circlip (30).
96. Refit the fork, the sleeve assembly, the link shaft
and the coupler. Fit the sleeve (28) with the long
offset between the pin and the 4WD pinion turned
as shown in Fig. 15. Replace the pins. Adjust the
fork (see section 5).
Tractor with no creeper unit
97. Refit the pinion (31). Refit the circlip (30).
98. Refit the assembly (link shaft and sleeves) then
position the coupling sleeves (27) (28) on the shaft
(29).
99. Fit two new double pins (25) (26) on the coupling
sleeves.
N
OTE: Fit the sleeve (28) with the long offset
between the pin and the 4WD pinion turned as
shown in Fig. 15. The long double pin is fitted on
the sleeve (27).
Tractors with or without creeper unit
100. Refit the right-hand hydraulic cover (see section 9).
N
OTE: If you have disassembled the 4WD clutch
assembly, the cones and cups, the shaft and roller
bearings, see section 8 for reassembly.
101. Place the sliding gear (10) on the shaft (32).
N
OTE: Turn the small shoulder E towards the shaft
(32) (Fig. 16).
102. Refit shaft (8). Carry out operations 63 to 81.
103. Top up the oil level in the rear axle. Refit the hook
(if adjustment is necessary, see section 6). Check
correct operation of the GSPTO.
Fig. 15
Fig. 16