MASSEY FERGUSON 5400 - Reassembling the Power Take off (2 WD Version)

Massey Ferguson 5400 - Issue 1.a
07E01.9
GPA20 - GSPTO
D . Reassembling the power take off
(2WD version)
38. Check and clean all components. Replace any
defective parts.
In case of servicing on the pinion (31)
Tractors with a creeper unit
39. Refit the pinion (31).
40. Refit the circlip (30).
41. Refit the fork, the sleeve assembly (28) (the long
offset between the pin and the pinion positioned
as shown in Fig. 10), the link shaft and the coupler.
Replace the pins. Adjust the fork (see section 5).
Tractors with no creeper unit
42. Refit the pinion (31).
43. Refit the circlip (30).
44. Refit the assembly (link shaft and sleeves) then
position the coupler sleeves (27) (28) on the shaft
(29).
45. Fit the double pins (25) (26) on the coupling
sleeves.
N
OTE: Turn the sleeve (28) as in operation 41.
Replace the pins. The long pin is fitted in sleeve
(27).
Tractors with or without creeper unit
46. Insert cup (14) in abutment on the shoulder of the
housing.
47. Insert cone (19) on shaft (18) in abutment on the
shoulder, using a press and a suitable fixture, then
position circlip (17).
Fig. 10