MASSEY FERGUSON 5400 - Page 420

Massey Ferguson 5400 - Issue 1.a
07E01.8
GPA20 - GSPTO
11. Take off the circlip (4) (Fig. 9).
12. Take out shaft (8) with bearing (5) then remove
sleeve (10).
N
OTE: If necessary, remove circlip (7).
13. Take off circlips (6) (9).
14. Extract bearing (5) using a press.
15. Extract plug (24).
16. Take off the circlip (23) and spacer (22).
17. Remove shims (21).
18. Remove cup (20).
19. Take out shaft (18) complete with bearing cone
(19).
20. Take off circlip (17) and hold pinion (16).
21. Remove pinion (16) and bearing cone (15).
22. Extract the cone (19) and take the circlip (17) off
the shaft (18).
N
OTE: Match the cones and cups if they are to be
reused. Bearing (13) is force fitted in shaft (18).
23. Extract cup (14) using a suitable extractor.
N
OTE: If pinion (31) is removed, it is necessary to
remove the right-hand hydraulic cover.
24. Chock the wheels of the tractor.
25. Apply the handbrake.
26. Raise the tractor using a jack.
27. Position the axle stand.
28. Disassemble the wheel.
29. Remove the right-hand hydraulic cover (see
section 9).
Tractors with no creeper unit
30. Drive out the double pins (25) (26) from the
coupling sleeves (27) (28).
31. Slide the sleeves towards each other on the shaft
(29).
32. Remove the shaft and sleeves assembly.
33. Take off circlip (30).
34. Remove pinion (31).
N
OTE: On 2WD tractors (without a GSPTO) the
pinion (31) is absent, but circlip (30) must be fitted.
Tractors with a creeper unit
35. Remove the fork, the sleeve assembly, the link
shaft and the coupler.
36. Take off circlip (30).
37. Remove pinion (31).
Fig. 9