MASSEY FERGUSON 5400 - Page 150

Massey Ferguson 5400 - Issue 1.a
05E02.12
Selector cover - GBA20 with Power Shuttle
Refitting (Fig. 1)
15. Clean the mating faces of the gearbox and the
cover.
16. Place the 3rd - 4th gear fork in ratio 3 (Fig. 8)
I
MPORTANT: Before refitting the cover, check for
the presence of the screw (1) (Fig. 8).
17. Coat the mating face of the housing with a sealing
product such as Loctite 510 or equivalent.
18. Turn the finger (13) (Fig. 8) toward the left.
19. Position the cover on the gearbox, checking that
the finger is correctly placed in the forks.
20. Refit the creeper control cable bracket (if fitted).
21. Refit the grounding lug (2). Fit and tighten screws
(3) (4) and the nut (6) to a torque of 50 - 70 Nm.
22. Depending on the option, reconnect and adjust the
creeper control (see section 5).
23. Reconnect the wiring harnesses to the tempera-
ture probe (5) and the Neutral position switch.
24. Reconnect the gear shift lever and reconnect the
cell. Carry out the operations 8 to 10 in reverse
order.
25. Using a grease gun, grease the links of the gear
shift control on the selector cover.
Legend Fig. 8
A Indexing pin for locking of Hare / Tortoise fork
L Synchronising the Hare / Tortoise system in Hare
(3) Gear engaged: 3rd gear, for example
(1) Screw
(9) Selector cover
(13) Finger
(18) Stop