MASSEY FERGUSON 5400 - Page 423

Massey Ferguson 5400 - Issue 1.a
07E01.11
GPA20 - GSPTO
60. Replace or clean the plug (24) and its mating face
on the housing.
61. Smear the corner of the plug housing with Loctite
542 and then insert the plug.
62. Place the sliding gear (10) on shaft (18).
N
OTE: Turn the small shoulder E towards the shaft
(18) (Fig. 12).
63. Fit circlips (6) (9) on shaft (8).
64. Using a suitable fixture, insert bearing (5) using a
press, on shaft (8), in contact with circlip (6).
65. Check for the presence of circlip (7).
66. Fit the shaft assembly (8) in the housing (Fig. 13).
67. Fit the circlip (4).
68. Place pinion (3).
69. Fit the circlip (2) (Fig. 14).
70. Check the movement of the sliding gear (10)
through the opening of the cover (12).
71. Replace or clean the plug (1) and its mating face on
the housing.
72. Smear the plug with Loctite 542, then insert it
slightly recessed from the face of the housing.
73. Fit the link (7) (fitted with a new O'ring (5)) by
placing pad (1) in the groove of the sliding gear (10)
(Fig. 5).
74. Clean and degrease the mating faces (cover and
housing).
75. Smear the mating face of the cover with a sealing
product (Masterjoint 510 or equivalent).
76. Screw two opposing guide studs into the housing.
77. Fit the retainer pipe (4), control link, locking stud (2)
and spring (3) (Fig. 5).
78. Refit the cover (12) and the lubricating pipe of the
engine clutch or Power Shuttle (depending on
version).
Fig. 12
Fig. 13
Fig. 14