Massey Ferguson 5400 - Issue 1.a
06E01.19
GPA20 differential
Shimming
92. Carry out shimming to obtain:
P2 = 0 to 0.25 mm(Fig. 25)
93. Place a steel ruler edge against the two calibrated
spacers (Fig. 26).
94. Using a set of laminated shims, measure the clear-
ance “J” between the finger of the tool and the
ruler “B” (Fig. 26).
95. Calculate dimension “C” between bearing cup (14)
and the mating face of the flange (9) (Fig. 27).
C = (114 + J) - 70
Fig. 25
Fig. 26
Fig. 27
To Next Page
Loading...
