MASSEY FERGUSON 5400 - Page 320

Massey Ferguson 5400 - Issue 1.a
06E01.20
GPA20 differential
96. On flange (9), measure dimension “Y” using a
depth gauge and a ruler (Fig. 28).
97. Select the thickness “E” of the deflector (13) and
shim (49) (if used) (see table) to obtain:
E = P2 + (C - Y)
N
OTE: To carry out “P2” shimming, nine different
deflector thicknesses are available.
N
OTE: If possible, shim to the maximum tolerance.
98. Remove the shimming tool and cup (14).
Fig. 28
Mating face of cup (14)
Mating face on the housing
Fig. 29
Centring punch holes
Reference
Number of centring punch
holes (Fig. 29)
mm
Deflectors
187,689 M2 0 0,73 - 0,78
892,173 M2 1 0,864 - 0,914
892,172 M2 2 0,991 - 1,041
892,171 M2 3 1,118 - 1,168
892,170 M2 4 1,245 - 1,295
191,124 M2 5 1,37 - 1,42
191,125 M2 6 1,49 - 1,54
521,401 M2 7 0,61 - 0,66
1 686 054 M2 8 0,50
Shim 3794403H1 - 0,70