Massey Ferguson 5400 - Issue 1.a
05E02.14
Selector cover - GBA20 with Power Shuttle
Final operations
26. Check the smooth engagement of all gears. If
required, adjust the control (see § E).
27. As necessary, refit those components removed
previously from around the cover.
28. Refit the wheel. Tighten the wheel nuts to a torque
of 400 - 450 Nm.
29. Top up the oil level in the housings. Check it using
the gauge at the rear of the centre housing.
30. Remove the shims between the frame and the
front axle. Release the handbrake.
31. Check that the buzzer of the safety cell vibrates
correctly (ignition on, handbrake on and gear
engaged).
32. Start the engine.
On the road, check the correct changing up and
down of the gear ratios, as well as the operation of
the Hare / Tortoise range using the pulse button
located on the gear shift lever pommel.
33. Check the oil tightness of the selector cover
mating face and of the hydraulic unions.
To Next Page
Loading...
