MASSEY FERGUSON 5400 - Page 154

Massey Ferguson 5400 - Issue 1.a
05E02.16
Selector cover - GBA20 with Power Shuttle
Reassembly (Fig. 1)
44. If it was necessary to remove the guide bush (26),
lightly smear its rim with Loctite 648 or equivalent.
Fit it up against the shoulder of the cover.
On the bracket (16)
45. If necessary:
- fit home the locating rings (17),
- refit the gearbox grid (14) on the bracket (16),
- tighten screws (19), lightly smeared with
Loctite 270 or equivalent, to a torque of 29 - 37
Nm.
46. Check that:
- the plunger (31) and indexing pin (35) move
freely in support (16),
- the flat section of the toggle (34) slides normally
on the finger (13).
47. Slide the pin of the finger (13) into the bracket (16).
48. Turn the toggle (34) as required. Fit it onto the
finger (13). Fit washer (33).
49. Refit spring (20) and washer (21). Fit the circlip
(22).
50. Slide the plunger (31) into its cavity in the bracket
(16).
51. Place finger (13) in the Neutral position. Turn the
indexing pin (35) as required and fit it.
On the cover (9)
52. Check for the presence of locating rings (17).
53. Refit the bracket (16) and gear shift assembly on
the cover (9).
54. Lightly smear the thread of the screws (15) with
Loctite 242 or equivalent. Tighten to a torque of
29 - 37 Nm.
55. Protect the lip of the seal (25) by surrounding the
cylindrical end of the finger (13) with a flexible
protection. Lightly smear the external rim of the
seal with Loctite 542 or equivalent and slide it onto
the protection. Remove the protection. Insert the
seal into the cover using a suitable fixture.
56. Check that finger (13) is in the Neutral position.
57. Slide ball (18) into the depression on the toggle
(34).