Massey Ferguson 5400 - Issue 1.a
06G01.8
GPA20 hitch hooks
Adjusting the control
On the lever (Fig. 6)
10. Place the lever (1) in the “neutral” position.
11. Adjust the nuts to obtain the same thread length
(2) on either side of the bracket (3).
N
OTE: Check that the cable is not pinched.
On the auto-hitch control (Fig. 7)
12. Screw the clevis (1) flush with the threaded end of
the cable (2).
13. Fit the clevis on link B using the clip (3) and check
that the link is in the locked position. Tighten nut
(4).
14. Assemble the sheath end (5) in the bracket (6) and
tighten the nuts (7) (8) so that there is no play in the
cable (2) and the cable is not pinched.
N
OTE: During adjustment, ensure that link B
remains locked.
Fig. 6
Fig. 7
To Next Page
Loading...
