Massey Ferguson 5400 - Issue 1.b
09B01.12
Right-hand cover – 57 l/min Open Centre
24. Attach the electrical harnesses using a cable clip.
25. Reconnect the pipes and hose.
26. Refit the trailer braking spool valve (if fitted - see
chapter 9).
27. Check the condition of the strainer seal (18) and
lubricate it. Refit the strainer and tighten it an addi-
tional quarter turn after it contacts with the seal.
28. Refit the 15 micron filter(s) and the support.
Reconnect the clogging indicator.
Final operations
29. Lift the tractor. Refit the wheel.
Take out the stand and tighten the nuts
(see chapter 6).
Remove the chocks.
30. Top up the transmission oil level of the rear axle
and check it using the gauge located to the rear of
the centre housing.
31. Check the operation of the electrical circuits, the
low pressure switch, the solenoid valves, the filter
switch and the filter clogging indicator.
32. If the pump has been replaced, or if the disas-
sembly of one or several hydraulic component(s)
was necessary, check the hydraulic circuit by
carrying out the relevant tests (voir chapter 9).
33. Check the tightness of the cover mating face, the
strainer and the hydraulic unions.
To Next Page
Loading...
