MASSEY FERGUSON 5400 - Page 489

Massey Ferguson 5400 - Issue 1.a
09C01.5
Left-hand cover - 57 l/min Open Centre
Preparing for refitting
9. Clean the mating faces of the housing and the
cover.
10. Check that the O’rings of the transfer pipe (11) are
not damaged and refit it on the right-hand cover
(Fig. 4).
11. Lightly smear the mating face of the housing with
a sealing product (Loctite 510 or equivalent).
12. Screw two locally made guide studs “G” into
opposing holes on the housing (Fig. 4).
Refitting
13. Refit the cover.
14. Fit the handbrake control support (6) and the
proportional PTO support (9) (if fitted) (Fig. 3). Take
out the guide studs. Fit and tighten the screws (5)
to a torque of 72 - 96 Nm.
15. Reconnect the pipes, hoses and harnesses
removed previously, according to their marks.
16. Attach the harnesses using one or more clip retai-
ners.
I
MPORTANT : Check that they can move freely and
easily.
17. Use cables to connect the controls.
18. Check the control setting for:
- handbrake,
- GSPTO (if fitted).
Final operations
19. Attach or refit the fuel tank (see operation 2).
20. Refit the wheel. Remove the axle stand and trolley
jack. Tighten nuts (see chapter 6).
21. Top up the oil level in the rear axle and check it on
the gauge located at the rear of the centre housing.
22. Start the engine.
23. Check the operation of the lifting system and the
oil tightness of the mating face, cover and
hydraulic unions.
Fig. 3
Fig. 4