Massey Ferguson 5400 - Issue 1.a
09F01.17
Lift control spool valve - Open Centre
Preparing for refitting
7. Clean the mating faces of the cover and lift control
spool valve.
8. Replace the O’rings (if necessary).
Refitting
9. Refit the spool valve.
10. Fit and tighten the screws to a torque of 36 -
46 Nm.
11. Reconnect:
- the pipes and hoses (see operation 5);
- the solenoid valve harnesses (see operation 4).
12. Attach the harnesses using one or more clip
retainers, if necessary.
Final operations
13. Attach or refit the fuel tank (see operation 3).
14. Refit the wheel. Remove the safety stand and
trolley jack (see chapter 6).
15. Start the engine.
16. Check the operation of the lift control system and
the oil tightness of the seals and unions.
To Next Page
Loading...
