MASSEY FERGUSON 5400 - Page 589

Massey Ferguson 5400 - Issue 1.a
09I02.17
Assisted brake master cylinders
Installation
7. Locally make a hose (2) for couplers as follows:
- one end must be fitted with a female connector
suitable for attachment to the male connector of
the brake master cylinders;
- the other end must be fitted with a female
connector suitable for attachment to the male
connector (3) of the right-hand hydraulic
connector (Fig. 14).
8. Connect a transparent pipe to the right- and
left-hand bleed screws (1) (Fig. 15)
of the centre
housing.
9. Dip the ends of the two pipes into the oil filling pipe
of the housings.
N
OTE: Check that the PTO is switched off and take
care not to insert the transparent pipes deep into the
oil filling pipe.
10. Locate the return hose (1) of the brake master
cylinders and pinch it shut without flattening it
excessively (Fig. 16).
N
OTE: Some hoses may be difficult to pinch shut due
to their rigid sheath. Consequently, it is recommended
to disconnect the hose from union (10) or (11) (Fig. 14)
and temporarily screw a plug in its place.
Fig. 15
Fig. 16