Massey Ferguson 5400 - Issue 1.a
09K01.20
57 l/min Open Centre tests
Checking the dry clutch pressure
CAUTION: The pressure can reach 30 bar
when the pedal is pressed down; it is therefore
necessary to connect the pressure gauge after
starting the engine.
- Connect a pressure gauge with a capacity of 30 bar
fitted with a coupler ref. 3582045M1 to the diagnos-
tics connector (1) located on the right-hand side of
the gearbox (Fig. 16).
- Run the engine at 1000 rpm.
- Measure the pressure:
P8 = 1.5 bar maximum clutch engaged
P8 = 13-15 bar clutch disengaged: new disc
P8 = 18-20 bar clutch disengaged: worn disc
Fig. 17
To Next Page
Loading...
