MASSEY FERGUSON 5400 - Page 760

Wintest - Issue 5.a
GUF511.4
AUTOTRONIC 5 - PowerShuttle - Programming and setting
parameters
Autotronic 5 programming is a 3-step process:
1. Searching for calculators present on CAN network
2. Selecting a calculator to be programmed
3. Selecting a soft to integrate into the calculator
4. Starting programming
The following screen is displayed:
N
OTE: Each stage must be validated to progress to the
following stage.
If a stage is dimmed, the previous stage has not been
validated.
Soft PowerShuttleSoft Parklock
Aut
o
5 Parkl
o
ck-
n
˚
002
696
MA-11-01277A
Fig. 1
1. Searching for calculators present
on CAN network
2. Selecting a calculator to be
programmed
3. Selecting a soft to integrate into
the calculator
4. Starting programming
Programming Auto 5
Programming
Scanning CAN network
File selected: Auto 5 PowerShuttle - V01.03-B4
Auto 5 present on the CAN network
Auto 5 selected: Auto 5 ParkLock-n° 002696
serial n° Application
H01/B03 -> V02.01 Update -> V02.02