DP-20 PLUS Web Guide Controller 6-9
4th Quarter 2021 © 2021 Maxcess International. All rights reserved. Figure Sheet 2-320 A
7. Once the Auto Setup is complete, if it was
successful, SUCCESSFUL will be displayed for
a few seconds on line 3, then the unit will
automatically exit the menus and return to the
Operator Level. The Guide Point is set to 0. If a
Deadband was stored before Auto Setup was
performed, the Deadband setting is restored.
8. Once the Auto Setup is complete, if it was not
successful, FAILED will be displayed on line 3.
Press the MANUAL key to exit the setup menus
and return to the Operator Level. The Guide
Point and Deadband are restored to the values
stored before the Auto Setup was attempted.
Repeat this procedure, as required.
3X.1.6, Servo-Center Gain
1. Press the SETUP key to enter the Setup Menus.
The SELECT MENU screen will be displayed on
the LCD Panel.
2. Press the ENTER key to enter the BASIC
Menus. The GAIN menu will be displayed.
3. Use the ARROW keys to scroll until ~ƒ GAIN is
displayed on line 3.
4. Press the ENTER key to allow adjustment of the
Servo-Center Gain. The current Gain value will
begin flashing on line 4.
5. Use the ARROW keys to adjust the Gain value
to the desired level as indicated on line 4. If an
ARROW key is held down, the speed of the Gain
change increases. The change is effective
immediately, but not stored.
6. If desired, press both of the ARROW keys
simultaneously to reset the Servo-Center Gain
to 5.0% as indicated on line 4.
× 3A.1.6.1
SETUP (SC)
~ƒ GAIN
ãÜÜÜÜÜÜÜÜÜ 5.0%
× 3A.1.6.1
SETUP (SC)
~ƒ GAIN
ããÜÜÜÜÜÜÜÜ 8.0%
× 3A.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
× 3A.1.6
SETUP (MAN)
~ƒ GAIN
ãÜÜÜÜÜÜÜÜÜ 5.0%
× 3A.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.1.6.1
SETUP (SC)
~ƒ GAIN
ãÜÜÜÜÜÜÜÜÜ 5.0%
× 3B.1.5.4
SETUP (MAN)
SUCCESSFUL
× 3A.1.5.3
SETUP (MAN)
FAILED
To Next Page
Loading...
Need help?
General
