DP-20 PLUS Web Guide Controller 6-25
4th Quarter 2021 © 2021 Maxcess International. All rights reserved. Figure Sheet 2-320 A
8. Press the ENTER key to select CHANGE.
ENTER PASSWORD will be displayed on line 3.
9. Using the proper keys, enter the desired new
password. Each key press is indicated by an “*“
on Line 4. The MANUAL and ENTER keys are
not allowed to be used in passwords.
10. Press the ENTER key to accept the password.
REENTER PASSWORD will be displayed on
line 3.
11. Using the proper keys, re-enter the desired new
password. The password must be the same as
previously entered. If a different password is
entered, “WRONG PASSWORD“ will be
displayed.
12. Press the ENTER key to store the new password
or press the MANUAL key to abort the
procedure. The system will exit the setup menus
and return to the Operator Level.
3X.3.4, Set Output A Delay
1. Press the SETUP key to enter the Setup Menus.
The SELECT MENU screen will be displayed on
the LCD Panel.
2. Use the ARROW keys to scroll until
ADVANCED is displayed on line 4.
3. Press the ENTER key to enter the Advanced
Menus. The RESTORE SETTINGS menu will be
displayed.
4. Use the ARROW keys to scroll until SET
OUTPUT DELAY, OUTPUT A is displayed on
line 3. The current delay time is displayed on
Line 4.
5. Press the ENTER key to enter the SET OUTPUT
DELAY menu. The current delay time will begin
flashing.
× X3A.3.3.2
SETUP (MAN)
ENTER PASSWORD
× X3A.3.3.3
SETUP (MAN)
REENTER PASSWORD
× X3A.3.3.2
SETUP (MAN)
ENTER PASSWORD
******
× X3A.3.3.3
SETUP (MAN)
REENTER PASSWORD
******
× 3C.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.3.4
SETUP (MAN)
SET OUTPUT DELAY
OUTPUT A: 0.00s
× 3A.3.4.1
SETUP (MAN)
SET OUTPUT DELAY
OUTPUT A: 0.00s
× 3A.3.1
SETUP (MAN)
RESTORE SETTINGS
× 3A.3
SETUP (MAN)
SELECT MENU
ADVANCED
× 3A.3.3.4
SETUP (MAN)
PASSWORD STORED
To Next Page
Loading...
Need help?
General
