134
Controls in detail
Seats
Seat cushion depth
왘 Press switch forward or backward in
direction of arrow 6 until your legs
are supported comfortably.
Seat cushion tilt
왘 Press switch up or down in direction
of arrow 7 until your upper legs are
lightly supported.
Seat fore and aft adjustment
왘 Press switch forward or backward in
direction of arrow 8 (
컄 page 133).
Leg rest length
왘 Press switch up or down in direction
of arrow 9 (컄 page 133) to adjust
the leg rest length.
Leg rest tilt
왘 Press switch up or down in direction
of arrow a (
컄 page 133) to adjust
the leg rest tilt.
Extending and retracting the rear seat
head restraints
1 Switch for rear seat head restraints
왘 Switch on the ignition (컄 page 60).
i You can only retract the rear seat head re-
straints when no rear seat passenger is wear-
ing a seat belt.
Retracting rear seat head restraints
왘 Press switch 1.
The rear seat head restraints retract.
Extending rear seat head restraints
왘 Press switch 1 again.
The rear outer seat head restraints
extend to your last set position.
or
왘 Adjust the head restraints with the
seat adjustment switches in the rear
passenger compartment.
i When you fasten your seat belt in the
rear, the respective rear outer seat head re-
straint extends to your last set position.
i The rear center seat* head restraint can-
not be extended using the switch in the front
center console. Use the switch on the lower
right side of the rear center seat.
컄컄
Warning! G
For safety reasons, always drive with the
rear seat head restraints in the extended
position when the rear seats are occupied.
Keep the area around head restraints clear
of articles (e.g. clothing) to not obstruct
the retracting/extending operation of the
head restraints.
To Next Page
Loading...
