174
Controls in detail
Control system
왘 Press button j or k repeatedly
until the message
LOCATOR LIGHTING
appears in the multifunction display.
The selection marker is on the current
setting.
왘 Press button æ or ç to switch
the locator lighting function
ON
.
왘 Turn the exterior lamp switch to
position U when exiting the vehi-
cle (
컄 page 142).
The locator lighting feature is activat-
ed.
Setting ambient lighting
Use this function, you can adjust the
brightness of the ambient lighting.
왘 Move the selection marker with
button
æ
or
ç
to the
LIGHTING
submenu.
왘 Press button
j
or
k
repeatedly
until the message
AMBIENT LIGHTING
appears in the multifunction display.
The selection marker is on the current
setting.
왘 Press button
æ
or
ç
to select the
desired brightness of the ambient
lighting.
The setting
LEVEL 1
represents the
darkest level and setting
LEVEL 5
the
brightest level.
The ambient light is switched off at
setting
OFF
.
Setting night security illumination
(Headlamps delayed switch-off feature)
Use this function to set whether you
would like the exterior lamps to remain
on for 15 seconds during darkness after
exiting the vehicle and all doors closed.
With the headlamps delayed switch-off
feature activated and the exterior lamp
switch in position U before the engine
is turned off, the following lamps will
switch on when the engine is turned off:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
앫 Front fog lamps
If after turning off the engine you do not
open a door or do not close an opened
door, the lamps will automatically switch
off after 60 seconds.
왘 Move the selection marker with
button
æ
or
ç
to the
LIGHTING
submenu.
왘 Press button
j
or
k
repeatedly
until the message
HEADLAMPS DELAYED
SWITCH-OFF
appears in the multifunc-
tion display.
The selection marker is on the current
setting.
컄컄
To Next Page
Loading...
