444
Technical data
Fuels, coolants, lubricants, etc.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze
solution or other products approved by
us for use on Maybach vehicles of equal
specification are used to renew the cool-
ant concentration or bring it back up to
the proper level.
For information on other products
approved by us for use on Maybach
vehicles of equal specification, refer to
the Factory Approved Service Products
pamphlet (USA only) or contact an
authorized Maybach Studio.
To provide important corrosion protec-
tion, the solution must be at least 50%
anticorrosion/antifreeze (equivalent to
freeze protection to approximately -35°F
[-37°C]). If you use a solution that is more
than 55% anticorrosion/antifreeze
(freeze protection to approximately
–49°F [–45°C]), the engine temperature
will increase due to the lower heat trans-
fer capability of the solution. Therefore,
do not use more than this amount of an-
ticorrosion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze
should be used to bring it up to the prop-
er level (have cooling system checked for
signs of leakage). Please make sure the
mixture is in accordance with label in-
structions.
The water in the cooling system must
meet minimum requirements, which are
usually satisfied by normal drinking wa-
ter. If you are not sure about the water
quality, consult an authorized Maybach
Studio.
To Next Page
Loading...
