12.3.4.4 WAN Settings
Enter a free WAN IP address and the net mask from your system or machine network. It is not compelling to
make an entry, just if you have plugged in the WAN-connector. If you have a Device with a modem module,
you do not need the WAN IP-address.
You can select between static IP and DHCP.
Type: Static IP
Use the static IP-address if you do not have a DHCP-Server in your Network. Notice that you have to use a
DNS-Server.
IP Enter the IP-Address of the external Router.
Netmask Enter the subnet mask of the corresponding network, in which the device is to be inte-
grated.
Gateway Enter the respective gateway that connects you to the Internet, so the IP address of
the existing device.
DNS Server Select the DNS server that was assigned to you by your Internet service provider
(ISP), or enter your own DNS server.
Type: DHCP
Select this, if a DHCP server exists in the network and is assigned to the device automatically get an IP ad-
dress (contact in this regard also to your network administrator!).
Gateway Enter the respective gateway that connects you to the Internet, so the IP address of
the existing device.
DNS Server Select the DNS server that was assigned to you by your Internet service provider
(ISP), or enter your own DNS server.
Initial configuration | Page 47 of 131
To Next Page
Loading...
Need help?
General
