13.3.2.4 Firewall Einstellungen - Create new 1:1 NAT
Navigation: Administration > Projects > ProjektAlpha (selected project) > RouterAlpha (selected device) >
Services > Firewall
This setting enables two networks in the same address range to be connected. If, for example, a network with
the address 192.168.0.0/24 is to be connected to a net-work with the same address, this is only possible if one
of the two networks is assigned another address. NAT technology is an easy way of achieving this since only the
real network address (LAN address) and the substitute address (NAT network address) are required. The NAT
algorithm makes sure that the addresses in the data packets are only substituted in communications between
these two networks. This means that you do not have to adapt your entire network addressing scheme.
1:1 NAT
Active Checkbox zum Aktivieren/Deaktivieren der Funktion.
Netaddress LAN Enter the real address of the network here (e.g.192.168.0.0/24).
Note that the IP address must be entered in CIDR notation.
Netaddress NAT Enter the translated address of your network here (e.g. 192.168.1.0/24).
Note that the IP address must be entered in CIDR notation.
Netaddress Re-
mote Station
Enter the address of the network to which the translated packets are to be routed here.
If the remote station also uses address translation, the NAT address of the remote sta-
tion must be entered here.
Page 96 von 131 | Version: 2.2.1 - EN | Mar 28
th
, 2022 |
To Next Page
Loading...
Need help?
General
