12.7.2.2 Transfer configuration to the device - via CTM
Here the mbCONNECT24 configuration is placed in the CTM (Configuration Transfer Manager) to be collected
by the mbNET.mini. On the interface of the mbNET.mini, create an initial configuration so the device can
connect to the portal. The mbNET.mini will then collect its portal configuration from the CTM there.
NOTICE
For this transfer when creating a device, the device serial number must be entered!
Click on the disk icon in the Device Administra-
tion and then on "Prepare for CTM".
In the next window, select whether a notification
email should be sent and to which address as soon
as the device has collected the configuration.
After confirming via the interface "Prepare for
CTM", a symbol shows that the configuration is
ready to be collected in the CTM .
As soon as the mbNET.mini is connected to the
portal, it will collect its configuration.
By clicking on this symbol the data saved in the
CTM are shown.
The configuration can still be deleted from the CTM.
Page 66 von 131 | Version: 2.2.1 - EN | Mar 28
th
, 2022 |
To Next Page
Loading...
Need help?
General
