12 Initial configuration
Because the mbNET.mini was designed as a portal device, the initial start-up takes place via the web portal.
•
RSP mbCONNECT24 V 2.x
or
•
mbCONNECT24 V 1.x
Generally following procedure applies:
•
Add the mbNET.mini in the portal as a new device.
•
Enter the necessary basic data, so that the device can connect to the portal (for example, device
name, network settings, connection information, etc.).
•
Transfer the device configuration from the portal into the mbNET.mini.
Alternatively, you can enter the necessary connection basic data direct on the web interface of the de-
vice (see chapter: Initial configuration via the device web interface).
If the mbNET can establish a connection to the Internet, it logs on to mbCONNECT24 with this connec-
tion data and fetches its configuration.
* Some features, such as "USB over IP", "SEARCHoverIP" or the configuration of I/O 1 and I/O 2 as digital
input / digital output are not available in portal version V 1.x.
Initial configuration | Page 21 of 131
To Next Page
Loading...
Need help?
General
