Forwarding
Interface Use this selection field to specify the interface to which the forwarding is to be applied.
You can choose from:
•
Internet
•
WAN Ethernet
•
OpenVPN
•
All
Forwarding IP Enter the IP to which the data packets are actually to be sent here.
Forwarding Port Specify the port via which the data packets are actually forwarded here.
NOTICE
You can enter address ranges in the input fields for the IP address.
Example of address ranges: 192.168.0.100-192.168.0.110 or 192.168.0.20/30
Address listings are not possible!
In the input fields for the ports, you can enter ranges or enumerations.
Example of a port range: 502-504
Example of port enumeration: 502,677,555
Both, range and enumeration can not be used simultaneously in the same field.
NOTICE
Ranges must be separated by a hyphen (-) and enumerated by comma (,).
No spaces between the elements to be separated!
NOTICE
The input of IP and port is not mandatory. If neither an IP nor a port is specified, a rule applies only to
the selected interfaces.
Configuring your Router in the Remote Service Portal (V 2.x) | Page 95 of 131
To Next Page
Loading...
Need help?
General
