Medivators ADVANTAGE PLUS - CHAPTER 5 Introduction

100
Introduction
Error Reports
The MEDIVATORS
®
ADVANTAGE PLUS
®
Automated Endoscope Reprocessor system can report and
display different types of errors which signal and identify specic areas requiring attention. Error types
include:
• System Errors: A communication problem identied by the prex C with errors ranging from C-001
through C-099. This is an error caused by the Windows based PC or MEDIVATORS ADVANTAGE
PLUS system.
• Bar Code Errors: A bar code problem identied by the prex M with errors ranging from M-910
through M-940.
• Endoscope Errors: An endoscope problem identied by the prex S with errors ranging from
S-102 through S-177.
• Reprocessing Cycle Errors: A problem identied during the endoscope disinfection cycle
identied by the prex S with errors ranging from S-201 through S-297, and S-511 through S-832
• Control Errors (SCU): Lists any deviations in the disinfection program as monitored by the SCU
controller, and identied by the pre-x S with errors ranging from S-300 through S-399.
• Warning Errors: An alert or warning identied so that the operator is aware of a machine condition
that requires attention. Warnings are identied by the prex W and range from W-701 through W-821.