Medivators ADVANTAGE PLUS - No Water Supply; Unrequested Inlet Water Detected; Volume Measurement V1 > V2; Water Inlet Flow too High

107
S-282 Water inlet ow too high
S-283 Water inlet ow too low
S-285 No water supply
S-286 Volume measurement V1 > V2
S-287 Volume measurement V1 < V2
S-288 Unrequested inlet water detected
S-289 External water supply valve failed
S-292 Basin temperature sensor defective
S-293 Basin temperature too high
S-294 Basin temperature too low
S-297 Basin temperature too high
S-511 Measure contact time too short
S-660 MRC validation failed
S-671 “Machine control” locked by the other side
S-672 Wrong system side
S-810 Check Part A container, run replace uids utility
S-811 Check Part B container, run replace uids utility
S-814 Part A ll sensors do not agree
S-815 Part B ll sensors do not agree
S-819 Dosing reservoir A empty, run replace uids utility
S-820 Part A container empty, run replace uids utility
S-821 Part B container empty, run replace uids utility
S-824 Dosing reservoir A not empty
S-825 Dosing reservoir B not empty
S-831 Air cylinder does not charge
S-832 Air cylinder not discharged