9
Installation and Maintenance
Proper maintenance ensures effective disinfection and prolongs the life of the reprocessor.
• The MEDIVATORS
®
ADVANTAGE PLUS
®
Automated Endoscope Reprocessor must be grounded
in accordance with applicable regulations.
• The system default is factory-set for the specic disinfectant immersion time for RAPICIDE
®
PA.
• All pressure regulators are factory-preset. Do not adjust the settings. Contact your Technical Support
representative for assistance.
• Do not allow the washing solution to contact metal components.
• Do not use alcohol or alcohol-based products to clean the reprocessor cabinet.
• MEDIVATOR endoscope hookups are not autoclavable. The hookups are automatically disinfected
with each use due to their exposure to the entire disinfection cycle; no further disinfection or rinsing
is required prior to their next use.
• Do not remove covers, doors, or panels fastened with screws while the reprocessor is in use.
• Replacement parts must be ordered from the manufacturer to maintain the warranty.
• Do not block ventilation openings.
• Regularly check all cables, tubing, and drains for damage or leaks.
• Do not carry out any maintenance that is not described in this manual.
• Ensure that the power supply connection is accessible in the event that emergency disconnection is
necessary.
• Prior to undertaking any service or maintenance operations or when resetting the GFI, ensure that the
MEDIVATORS ADVANTAGE PLUS System is disconnected from the main power supply. If service
or maintenance operations are to be conducted on the water system, ensure that the MEDIVATORS
ADVANTAGE PLUS System is isolated from the main water supply.
For service or service-related questions, contact MEDIVATORS Technical Support at 1-800-444-4729 in
the United States or your local MEDIVATORS Distributor.
To Next Page
Loading...
