Medivators ADVANTAGE PLUS - Barcode Errors

113
Another program is active C-053
Cause: Machine disinfection should start but there is an active cycle running.
Action: Let the current program run to completion. When the MEDIVATORS
®
ADVANTAGE PLUS
®
Automated Endoscope Reprocessor is ready and the basin cover is still open, insert the machine
disinfection block and close the cover. The machine disinfection will start automatically.
Delayed start of program is not possible in the current state. C-060
Cause: Warning messages (numbers W700-W799) are present on the screen during automatic start up
of a disinfection program.
Action: Ensure that the messages are resolved. Select the automatic restart. Consult the maintenance
department if necessary.
Cause: Auto start for another program is already set up.
Action: For the delayed start, the other program must rst be shut down.
Tag-reader not available C-080
Cause: The identication system is defective.
Action: Report the error to the maintenance department and the MEDIVATORS ADVANTAGE PLUS
system manager to have the chip (=Tag) system disconnected.
Internal LIO failure : %s C-099
Cause: A wrong selection was executed when setting the machine system parameters.
Action: Report the error to the MEDIVATORS ADVANTAGE PLUS system manager to correct the
settings. Then restart the program.
Bar Code Errors
Unknown barcode M-910
If the system is set up to require the use of the bar code reader, manual selection with the cursor is not
possible.
Cause: The bar code belongs to another item to be read.
Action: Check if the bar code type is the same as the selected input eld on the screen. Scan the correct
bar code again.
Cause: The bar code is not entered in the management system.
Action: Report the error to the MEDIVATORS ADVANTAGE PLUS System manager along with a
request to add the bar code for the selected item.