81
4. Disconnect the channel adapters
5. Remove the channel separator(s).
6. Take the connector block out of the basin and hang up the block to dry.
7. Take the endoscope out of the basin.
8. If appropriate, t the valves.
9. The endoscope is now ready for a new examination. If it will not be used right away, the endoscope
must be stored in an airing cupboard or on a suspension rack.
10. If automatic cycle log printing is enabled, the log is printed.
Reports
Run Data Recorded
For each disinfection program run, the following data is recorded and stored on the PC hard drive:
• Machine ID
• Run number
• Date and time
• Endoscope Code
• Operator ID
• Patient ID
• Process step times
• Errors
• Disinfectant MRC Pass/Fail
• Additional information as set up by the system administrator
To Next Page
Loading...
