130
Stopped by operator S-360
Cause: During an active program, the Stop
button was pressed.
Action: The message is automatically stored in the run report.
Warning Errors
SCU: No connection W-701
Cause: A communication error occurred between the PC and the electronics drive controller.
1. No serial connection with the PC
2. The power or plug is disconnected
3. The drive controller is defective.
Action: Make certain all cables are connected to the PC and the 230V plug. Report the fault to the
maintenance department.
SCU: wrong conguration W-702
Cause: The Safety control program found a fault in one of the electronic components, or the controller
is not in the run.
Action: Report the fault with number to the maintenance department.
SCU: Incorrect status and lid inactive W-703
Cause: The Safety control program rejected the previous run and blocked the cover. The LED is red.
The cover remains closed under the following conditions:
• An error occurred during a recovery program.
• There was a power outage.
• There is a software error.
• The LIO-program shut down.
• There is an electronics error.
Action: The maintenance department can access the expert service to shut down the process in order
to make a repair.
• Run the disinfection program to a safe situation by starting a recovery program.
• Press the Start
button.
• Press the Menu
button.
• Select your operator ID
• Select the program recovery after aborted program.
• Press the Start
button.
• If this program is ready, then the cover can be opened to safely remove the endoscope. After
opening the cover, the message disappears and the red LED goes off. The status message
“ASC (rejection)” is applicable to the program. The instrument status “not appropriate for
use” is applicable to the endoscope.
To Next Page
Loading...
