Megmeet M5-N Series User Manual

Chapter 8 Drive Parameter Object
144
Parameter
No.
Sub-index
Name
Setting range
Minimum
unit
Default value
Effective
time
Property
P11.07
08h
Reserved
P11.08
09h
Reserved
P11.09
0Ah
Bus voltage
0~900V
1V
_
At
display
P11.10
0Bh
Reserved
P11.11
0Ch
Operation state of
the servo drive
0~FFFFH
Bit 0: RUN/STOP
Bit 1: REV/FWD
Bit 2: Running at zero
speed
Bit 3: Accelerating
Bit 4: Decelerating
Bit 5: Running at
constant speed
Bit 6: Reserved
Bit 7: Reserved
Bit 8: Over-current
limiting
Bit 9: DC
over-voltage limiting
Bit 10: Torque limiting
Bit 11: Speed limiting
Bit 12: Drive in fault
Bit 13: Speed control
Bit 14: Torque control
Bit 15: Position
control
1
_
At
display
P11.12
0Dh
DI terminal state
0~3FFH, 0: off; 1: on
The high-speed pulse
reference will not be
refreshed
synchronously
1
_
At
display
P11.13
0Eh
DO terminal state
0~FH, 0: open; 1:
close
The high-speed pulse
output will not be
1
_
At
display

Megmeet M5-N Series Specifications

General

Brand	Megmeet
Model	M5-N Series
Category	Servo Drives
Language	English